Interior Door Pull Finisher (Genuine) in Walnut for Defender L663 90 - RHD rear door badge In theory you need an

In theory you need an M8 rivnut fitting tool to fit these captive nuts but if you drill a hole and ensure the rivnuts are a tight fit and can't spin then in practice we find we can hammer the rivuts into the hole and then fit the step and the rivnut will tighten inside the chassis as you tighten the bolts

Gas struts are notorious for losing their mojo which can lead to the tailgate not staying up or becoming hard to open

The badge on the L322 should be located approx 115mm from the left edge and 136mm up from the bottom edge - see attached pictures

There is no soldering needed to fit this kit - we have pre soldered the switch and put solder on the end of the leads - the only thing you need to do is drill the small hole in the rear door "dish"

This item WILL fit the Range Rover L405 models with the large 5 pin connector from 2013 -2021 - check listing photo

Interior Door Pull Finisher (Genuine) in Walnut for Defender L663 90 - RHD rear door badge In theory you need anGenuine Door Pull Finisher in Walnut for Land Rover Defender L663 90 RHD This listing is for a genuine Land Rover walnut door pull finisher for the Land Rover Defender L663 90 model (2 door). You only need 1 finisher for the passenger (Left Hand Nearside) door as the drivers door is a different design and does not have a finisher. This listing is for RIGHT HAND DRIVE vehicles please see our other listing for left hand drive. These will not fit the